INSTRUCTIONS
iTECH120 120AH
Please follow and understand these instructions before using the
iTECH120, failure to do so can cause the battery to fail. It is
strictly prohibited to disassemble battery. Inside the battery are
electrolytes. These electrolytes can be a skin and eye irritant.
Don’t touch battery directly if you see any liquid on the battery.
If there is electrolyte on your skin, please use soap and water to
wash; if there is electrolyte on your eyes, please use lots of
water to wash it and go to hospital immediately.
Do not cross the polarity of the battery.
Never plug the battery directly into 240v mains power.
Do not open the casing.
Do not throw, squeeze, puncture, strike, contort, heat, burn, or
disassemble battery.
Keep children and animals away from the battery.
Battery should be stored in a dry environment away from water.
Battery operates best if kept above 12.8v.
When charging do not exceed 15v input. A battery charger with
cut out of 14.7v and under is best.
Can connect in series, up to 4 batteries, max 48V
Can connect in parallel up to 4 batteries. When connecting in
parallel all batteries voltage must be the same.
Do not use this battery with lead acid battery or other brand
battery in series or parallel.
Exposure to sunlight can increase discharge rate of battery.
If battery shows any shape change, colour change or any liquid
seeping from battery stop using immediately and contact
iTechworld.
If the battery terminal screws are corroded, be careful not to
bend the terminals when tightening or loosening.
Do no short-circuit the battery by directly connecting the
positive and negative terminals together or with metal
conductive objects.
Do not transport the battery together with metal objects that
are conductive.
When connecting a load to a battery bank in parallel please
follow the wiring diagram provided in this document.
SPECIFICATIONS
iTECH120 120AH
Nominal Voltage: 12.8v
Charging Voltage: 14.7v or less
Discharge cut off Voltage: 10v
Standard charge current: 18A
Maximum charge current: 50A
Standard discharge current: 100A
Max discharge current: 250A
Output connector: M8 Stud
Weight: 11kg
Dimensions: 330*173*215mm
Charge temp range: 0°c - 45°c
Discharge temp range: 20°c - 60°c
Storage temp: -10°c - 45°c
