IT6900 User Manual
Copyright ©ITECH Electronics Co., Ltd.
iv
Caution
Positive terminal
Warning (refer to this manual
for
specific
Warning
or
Caution information)
Negative terminal
A chassis terminal
-
-
Safety Precautions
General safety precautions below must be followed in each phase of instrument
operation. In case of failure to follow these precautions or specific warnings in
other parts of the manual, violation against the safety standards related to the
design, manufacture and purpose of the instrument will occur. If the user does
not follow these precautions, ITECH will bear no responsibility arising there
from.
The power supply is provided with a three-core power cord during delivery
and should be connected to a three-core junction box. Before operation, be
sure that the power supply is well grounded.
Use electric wires of appropriate load. All loading wires should be capable
of bearing maximum short-circuit of electronic load without overheating.
Ensure the voltage fluctuation of mains supply is less than 10% of the
working voltage range in order to reduce risks of fire and electric shock.
To prevent burnout, please pay special attention to positive and negative
polarities of power supply during connection!
Do not use damaged equipment. Please check the housing before using
the equipment. Check whether the instrument is subject to cracking or is
lack of plastic. Do not operate the instrument in the environment with
explosive gas, steam or dust.
Observe all tags on the equipment before connection.
Do not install alternative parts on the instrument or perform any
unauthorized modification.
Do not use the equipment when the removable cover is dismantled or
loose.
Please use the power adapter supplied by the manufacturer to avoid
accidental injury.
Do not use the equipment on the life support system or other equipment
with safety requirements.
If the equipment is not used in the manner specified by the manufacturer,
