www.itec-audio.com
3
DIGIPOWER 2x500T
ITEC DIGIPOWER 2x500T
Safety instructions
Please read this instruction manual carefully before installation and putting the “ITEC DigiPower” amplifi er
into operation. Keep this document easy to fi nd on a safe place to have it available as a later reference.
Instruct all persons dealing with this device and make them familiar with its use and in particular with the
safety regulations.
When installing the device, local connection conditions, required protective measures and all relevant
standards must be observed.
Do not block, cover or obstruct the vent slots: The air circulation has to remain ensured.
The device is designed for installations in 19“ cabinets / racks / frame / housing. Improper installations in
furniture, cabinets or distribution systems as well as a free putting have to be avoided.
Operate the device only via a grounded safety power outlet. Make sure the power cable is not damaged.
Never remove the ground wire of the feeder.
Before connecting to the mains supply check that the data on the backside of the device match with the local
network.
The device must necessarily be checked by trained personnel in case:
The power cable or plug are damaged, small objects or liquids got into the device, the device operates in a
different way than usual, the device was exposed to a severe impact or the housing has been damaged.
Extended storage or operating in rooms with high humidity, during rain or under the infl uence of splash water
can lead to damages or malfunctions.
Do not apply temperatures above 50 °C, humidity larger than 95% or rain to the device.
Never try to open the device by force or by unscrewing. The product does not contain parts that can be re-
paired by amateurs. Please contact the manufacturer or a local distributor.
For cleaning use a soft, dry cloth only. Never use cleaning agents or solvents which attack the surface or
could enter the device. Unplug the device before cleaning.
NOTE: Before carrying out any modifi cations of the device by a specialist, the device has to
be disconnected from all power sources both from the mains supply as well as from the 24V
DC
power
supply.
