Speaker Outputs
775mV/10K
MIC Input
5mV/600
Frequency Response
50Hz-18KHz (+2dB)
Less than 1% at 1KHz
230 115 56
1/3 rated power
,
Better than 85dB
0.9
4-8
Connection/Operation
Limiter
Specifications
Connect input sources such as CD player,DVD
player or projector outputs to the unit
’s inputs.
Select bridge or stereo function.
The unit shipped in stereo mode. To select bridge
mode,slide in the switch until it locks into position.
Connect the outputs from the unit to your
speakers.The stereo and bridge outputs are
labeled on the sperker outputs of the unit.
We recommend selecting the LIMITER ON
function,but the circuit may be disabled by
selecting the OFF position.
The limiter is a function that prevents very loud
signals from passing through it by limiting the
signal volume temporarily to a normal level.This
prevents damage to the speakers or the unit itself.
The limiter utilises a circuit that decreasws the
amount of very signals. It does not cut out all
potentially loud signal .Proper installation and
The limiters primary function is to help prevent
one time very loud s ignals such as a dropping
of a microphone or short loud parts of program
material.
Set up is crucial . If you are experiencing distortion,
turning the limiter on may help but it is not intended
for total dynamics control.
Line Input
THD
Supply Voltage
Dimensions(mm)
Efficiency
S/N Ratio
Weight
USER MANUAL
3
The holes in the sides of the unit
are for the attachment of a zip tie
(not included)for power cord strain
relief as required
WARNING:
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER.
NO USER SERVICABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
INPUTS
Mini Two Channel Mixer Amp
2X20watts
T-220AP
RISQUE DE CHOC ELECTRIQUE
-NE PAS OUVRIR
AVIS:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
SN:
