SECTION 3
GETTING TO KNOW YOUR MOTOR HOME
3-14
avoid electrical arcing when attaching and
detaching charger clamps.
6. After charging batteries, turn the Aux. Bat-
tery Switch off to disconnect the batteries
and avoid parasitic* drain. The inverter/
charger must be shut off at the control panel
to avoid draining the house batteries when
the Aux. Battery switch is turned off. The
inverter/charger is directly powered and is
not affected by the Aux. Batt. Switch.
7. Have the vehicle chassis completely serviced
and lubricated. Be sure radiator antifreeze
protection level is sufficient for the lowest
anticipated temperatures.
8. Wash and wax the coach.
9. Inspect all seams and seals around doors,
windows, vents, and any other joints.
Replace or repair any that are damaged.
Sealing materials and compounds can be
purchased from your dealer. Badly damaged
weather seals may need to be replaced by
your dealer.
10. Close all windows and roof vents. Protect all
appliance vent openings from contamination
by animals or insects (e.g. bird nests, wasp
nests, etc.)
11. Lubricate all door hinges and locks.
12. Clean the interior of the coach. Dirt and
stains are more easily removed when fresh.
NOTE: We do not recommend leaving the shore-
line plugged in continuously during stor-
age periods because the batteries can
lose electrolytic fluids and become dam-
aged from continuous charging without
periodic use. We recommend following
regular battery inspection and mainte-
nance, especially in cold weather. See
“Battery Storage and Maintenance” in
section 9.
*Parasitic battery drain is the gradual drain by
items connected directly to battery power such
as clocks and radio memory.
When storing your vehicle through the winter,
or in cold climates, extra preparations need to be
made to protect systems that can be damaged by
freezing temperatures. See “Winterizing” in
Plumbing Section.
REMOVAL FROM STORAGE
1. Completely air out the motor home.
2. Have the entire LP gas system checked for
leaks.
3. Check window operation.
4. Check cabinet and door hinges. Lubricate
with penetrating oil, if necessary.
5. Close all faucets and drain valves that are
open. If necessary, reconnect toilet water line
and close flush valve.
6. Add a few gallons of water to the fresh water
tank and check for leaks especially at junc-
tions. Also make sure all hangers and sup-
ports are securely in place. Sanitize the water
system as outlined under “Disinfecting the
Fresh Water System” in Plumbing Section.
7. Check operation of all faucets to be sure
faucet washers have not hardened during
storage.
8. Check sealing valve in the toilet for proper
operation and lubricate with silicone spray.
9. Add water to the holding tank using the toilet
flush pedal. Check to be sure dump valve
seals tightly.
10. Check around all appliances for obstructions
and ensure that all vent openings are clear.
11. Start refrigerator and check for proper cool-
ing.
12. Clean paneling and counter surfaces.
13. Replace batteries if necessary and check out
electrical system to make sure all lights and
electrical components operate.
14. Check tires for proper cold inflation pres-
sure. See Vehicle Certification Label on side-
wall near driver’s seat.
15. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents and any other joints.