ITALMOTO Tiquattro 125, Руководство пользователя

Страница: 22 / 44

●
Oil level and change oil
Check the engine oil before ride daily.
Must keep oil level in the middle of MAX
mark and MIN mark of the oil scale.
Inspection:
1.
Turn on the engine and keep it
idling for
3-5
minutes.
2.
Stop engine,use the main stand to
support the vehicle on a flat ground.
After 2-3 minutes, turn out the oil
scale
①
and clean it, then put it
back,
1
Min Max
(2)
Take out the oil scale, oil drainage bolt
①
and gasket,
drain out the oil completely, install the gasket and oil
drainage bolt, tightening torque: 30N.m.
2.
Put 1L specific oil to the engine, check if the oil level is
right.
3.
Install the oil scale.
4.
Turn on the engine, keep it idling for few minutes, turn off
the engine
5.
Check the oil scale again, keep the oil level in the middle
of max and min mark of oil scale, and engine no oil leaking.
Clean the oil filter
take out again and check the oil level. The oil level must be in
the middle of max mark and MIN mark of the oil scale.
3.
If necessary, add specific oil to the engine, but not beyond
the MAX mark of oil scale.
Change oil
Caution:
When the engine is not completely cooled down, it is the
best time to change oil. The body should support by
supporter and keep vehicle in vertical position and fast
leaking all the oil.
When it
'
s necessary, clean the oil filter.
1. Remove the right crankcase cover
2.
Take out the oil filter
②
,clean it and
put back according to the instruction.
Attention:
(1)
From the dust on the oil filter, can
check out if the engine is in good
condition. If there's too much metal
dreg, you need to inspect the engine.
2
Oil filter screen
Installatio n d irection
Oil drainage
(1)
Before oil drainage, put a
container under the crankcase.
1
(2)
Can't clean the oil filter by fuel or other liquor which is harmful
to rubber.
(3)
When install right crankcase, tighten the position bolt first, then
tighten other bolts diagonally. Tightening torque: 30N.m
16