itaia ADP 400, Руководство по эксплуатации

Страница: 9 / 20

Operating manual: ADP 400(s) / 800 6
2. 3. Indications and handling
In every of 3 modes, charger checks battery connection, condition, voltage and capacity.
Based on those data it defines charging time and current. Charging is set to optimal voltage
and current. When battery is full, charger goes to maintenance state. In this state it checks
charge regularly and if needed add some more charge to the battery. Time in this state can
be unlimited. When battery is disconnected, it is always fully charged and in optimal
condition. Charging/maintenance is indicated on control LED-s. Meaning of control lights and
sound signals during charging is shown In table 1.
CHARGING MODES SOUND SIGNAL RED GREEN YELLOW
Automatic – diagnostic
Charging
- blinking blinking -
Fast charging - blinking - -
Discharge – charging - - blinking -
ACTIVITY STATE SOUND SIGNAL RED GREEN YELLOW
Charging - ON - -
Maintenance - - ON -
SOUND SIGNAL RED GREEN YELLOW
FALSE CONNECTION
continuos sound
signal
- - blinking
CHARGER FAULT interval sound signal ON ON -
BATTERY FAULT interval sound signal ON ON -
Table 1: Meaning of control lights and sound signals
You can always check charging mode durring charging by pressing a button. After this
control LED-s shows charging mode for 10 seconds.
You can choose or change charging mode with doubble press on the button durring
charging, or pressing the button during the charging mode indication. Charging mode
changes cyclic: Automatic charging – Fast charging – Discarge-charge charging.
When battery is damaged or deteriorated, charger will sond continuos sound signal. At the
same time red and green LED will lit continuosly. The same indication also shows burned
fuse in the charger.