IntraSonic Technology, Inc. | 610 Presidential Drive Ste 104 | Richardson, Texas 75081 |
877.435.0670
www.intrasonictechnology.com
Trouble Shooting Tips and Questions
Problem or Question
Solution
Can not hear music at room stations
Volume controls operate independently. Make sure to adjust the
volume for each source
Check to see if the mode setting at the master is set for intercom only
or monitor/off
Can not hear room intercom
Volume controls operate independently. Make sure to adjust the
intercom volume for each station
Check to see if the mode settings at the master are set to music only
or monitor/off
Volume controls operate independently. Make sure to adjust the
volume for each room station and source.
Where do I put my hand held music player at
the room station?
A hand held music player bracket is sold separately. Contact your
installer or Intrasonic Technology for more information
Can I charge my hand held music player?
Only at the master can you charge a hand held music player. This is
done via the USB or firewire port in the docking station. Note some
players may not charge through these ports.
Can not hear the room station being monitored
Volume controls operate independently. Make sure to adjust the
intercom volume for each station
Make sure privacy control is not active
Where do I plug in my hand held music player at
the room station?
At every room and patio station, on the bottom, there is a 3.5mm jack.
Simply plug a 3.5mm cable (supplied with Master) into the jack and
plug the other end of this cable into the headphone jack on your music
device
Can not hear my hand held music player
Make sure you have LOCL (local) selected as the music source at the
station you are attempting to connect your hand held device.
Volume controls operate independently. Make sure to adjust the
volume for each music source at the station.
How do I monitor a baby’s room?
Using the remote control or master, select to room number you wish
to monitor and then press monitor. See “MONITOR” under remote
control section.
Using the remote, press monitor or select room number
What happens if the power goes off?
Like most electronic devices, when the power is off the equipment will
not operate. The I1000M has a battery backup that should keep the
owner selected settings during most power outages.
Where is the battery backup and how do I
replace it?
The battery backup is located behind the master front panel. Simply
loosen the three screws on the bottom of the master face plate and
pull the face plate off. In the upper right hand corner there is a square
cover with a single screw. Remove this screw and remove the battery
behind it. Watch the battery polarity and put the new battery in using
the same direction as the old battery. The battery number for
replacement is CR2032. After replacement remount the master face
plate and tighten the 3 screws on the bottom.
I cannot hear my MP3 player or other music
source that is plugged into the master docking
station throughout the home
There is a local and broadcast switch in master. To distribute music
throughout the entire system move the switch into the broadcast
position.
Page 19 of 20
