Ispring FG15B-KS, Руководство пользователя

Страница: 3 / 6

Open the COLD-water faucet and run water for about 10 minutes to expel any carbon
fines. Let the unit sit for several minutes, then repeat if necessary.
6. Turn off the faucet, and your system is now ready for use.
NOTICE:
The water will have a blackish color for the initial flush. This is caused by residual carbon dust
and is to be expected. Continue to run water until the color runs clear and all air has been
purged. It is not unusual for the water to appear "cloudy" for a day or so following installation.
This cloudiness is actually tiny air bubbles being purged from the filters. This is normal and will
cease after a few days of operation.
NOTICE:
After prolonged periods of nonuse (such as a vacation), it is recommended that the system be
flushed thoroughly for at least 10 minutes prior to use.
Filter Change Instructions
Step 1- Remove Old Cartridges
1.1 Turn off the water supply to the system. Open a nearby faucet to release the
remaining pressure and drain the water.
1.2 Unscrew the housings using the filter wrench included (AWR3) with your system, or
a commercially available “strap” type wrench.
1.3 Locate and remove the large O-ring using a small, clean flat head screwdriver. Avoid
removing any of the lubricant, and set it aside in a clean, safe place.
1.4 Remove and discard the old filter cartridges.
Step 2- Clean the Housings
2.1 Scrub the housings and caps with a mixture of warm water and about 2 tablespoons
of household bleach using a sponge or soft rag. For your safety, wear rubber gloves.
Rinse all parts very thoroughly!
2.2 Lubricate the O-ring with clean silicone grease if needed. DO NOT USE PETROLEUM
JELLY. Insert the O-ring into the filter groove and press into place
.
Verify the O-ring is
seated correctly.