INTRODUCTION
Congratulations on your purchase of the Vector 212 Extension Guitar cabinet. You are now
the owner of the most innovative guitar speaker combo cabinet ever produced. The same
innovation and killer sound that you can find in our Vector Cabinet and Theta Head is now
combined into one package and is ready for low-end players and shredders of all kinds.
Years of experience in designing the highest performance Active Sound Reinforcement
cabinets has allowed ISP Technologies engineers to develop the ultimate guitar combo
extension cabinet. The Vector 212 was designed to provide the maximum possible over the
top performance with stunning low-end punch and definition.
With 100 watts RMS
driving a single Celestion 12” speaker and 300 watts available to deliver the
thunderous low end, the Vector 212 really delivers the sound never before
available in a combo package.
Please read this manual carefully for a through explanation of the Vector 212 and its
functions.
IMPORTANT SAFETY INSTRUCTIONS!
NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE YEARS OF
TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDELING.
All warnings on this equipment and in the operation instructions should be adhered to and all
operating instructions should be followed.
Do not use this equipment near water. Care should be taken so that objects do not fall onto and
liquids are not spilled into the unit through any openings.
The power cord should be unplugged from the outlet when the unit is left unused for a long
period of time.
DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT SHOULD BE SERVICED BY
QUALIFIED SERVICE PERSONNELL ONLY. DO NOT MAKE ANY INTERNAL ADJUSTMENTS OR
ADDITIONS TO THIS EQUIPMENT AT ANY TIME. DO NOT TAMPER WITH INTERNAL
ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOLLOW THESE INSTRUCTIONS WILL
VOID THE WARRANTY OF THIS EQUIPMENT, AND MAY CAUSE A SHOCK HAZZARD.
POWER REQUIREMENTS
This unit requires connection to a 120-volt AC outlet. Do not cut or disconnect the ground pin
on the power cord. Do not attempt to connect this unit to any power source other than the
specified 120VAC. The Theta Combo will typically draw approximately three amps of current
when driving a 4-ohm load.
Содержание Vector 212
Страница 1: ......
Страница 4: ...Connection Diagram...
