Isotta 5DMARKIV, Инструкция по эксплуатации, Страница: 13 / 24

The back door features all key/main camera controls by means of clearly labelled
laser-engraved longlasting buttons. It has a large window anti-scratch polycarbonate
for a fine camera display view and optical viewfinder view. External viewfinders can be
mounted
ON REQUEST
,
INON X-2 compatible.
On the left of the back door there is a leaking acoustic LED alarm . This component
acts as an alarm in case of moisture inside the housing.
An internal sensor will turn on the
LED red
: in the event that this happens consult the
section
CORRECTION OF PROBLEMS.
Both LED and audible sensor are powered by an internal battery that is replaceable by
the user. The alarm system is protected by a cover.
The back of the housing is entirely detached from the front body to make easier the
camera fitting. To separate the Back from the housing is necessary to first disable the
safety. This is done by applying a slight upward pull to the locking knob located on
the upper part of the housing. You can then proceed with the removal of the back by
turning counterclockwise the knob. Turn the back until the locking pin is visible.
At this point proceed pulling out slightly the back and extracting on the opposite side
the two pins at the bottom from their seat.
The back door is equipped with
two O-ring seals.
We recommend to pay particular
attention to them: they must be kept clean, intact and properly lubricated.
BACK
OFF ON
Optical Trigger System / OPTIONAL
Only on request.
On the upper side the hotshoe features the
battery powered TTL electronic trigger to be
connected to the hotshoe of the camera. A
special internal slot located on the right top
of the housing interior allows you to lock the
hotshoe when not in use.
13