MEASUREMENT AND ASSEMBLY MANUAL
MEASUREMENT AND ASSEMBLY MANUAL
MEASUREMENT AND ASSEMBLY MANUAL
Instruction validity: as of 1 August 2013
10
When connecting the conductors to a terminal block inside the main switch, check which brown and black conductor
corresponds to opening and which to closing of the roller blind (this depends on which side of the drum the motor is to be
installed).
RTS MOTOR:
The motor cable has 3 conductors:
blue = phase/neutral conductor,
brown = phase/neutral conductor,
yellow-green = ground.
End switches for a motor installed in the winding drum are not pre-set, therefore the roller blind opening/closing positions
are completely random. Motor end switches can be set up in various methods, according to the type and mark of the motor
used. Instructions for the end switch programming and setting are specified in a separate manual.
To set up the end positions, first turn on the motor to roll the roller blind down, set the required locking position. Then set
the upper position (full draw). In both cases, the adjustment of both the open and closed positions of the roller blind must
not cause loading of the lower rail or fabric.
Prior to final connection and operation, check if the system works properly. Operate the roller blind for at least two
consecutive cycles and check the function of thermal disconnection after 4 minutes of continuous operation. To provide for
proper function of the roller blind, check if the winding drum is perfectly level after installation. Following the roller blind
installation, check if the end user understands the method of operation of the roller blind, and give this manual to the user
for future reference.
NOTE: There is a risk of compression in case a hand is trapped between the fabric and the upper box during the
roller blind updrawing. Before operating the roller blind, move your hands outside of the movement range to
prevent compression. Vibrations or excessive noise indicate damage or faulty installation of the roller blind.
8.2 TESTING
To provide for proper function of the roller blind, check if the winding drum is perfectly level after installation.
Following the roller blind installation, check if the end user understands the method of operation of the roller blind, and give
this manual to the user for future reference.
8.3 REMOVAL OF WINDING DRUM FOR MAINTENANCE
Removal of the winding drum and motor from the upper box is necessary only if the upper box is installed at the front.
Suspended roller blinds are supplied disassembled.
