Isotra ARTOSI, Руководство по измерению и сборке

Страница: 9 / 21

MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 21.3.2022
9
Wall Mounting – Variant B
Prior to taking any measurements, check the surface to which the pergola is to be installed. Measure the
surface inclination difference of level at the house wall and on the opposite side of the pergola. Place the
pergola in accordance with the c
lient’ instructions (to the centre, to the left side, etc.).
B.1 In locations A1 and C1 on the wall, mark out the places for the installation of the perimeter section
holders, based on the measure-taking. Take the measures by starting on one side and then indicating
the placement of the individual feet diagonally. Then indicate the anchoring holes. In doing so, pay
special attention to alignment and connection of the pergola poles to the water outflow. When taking
measurements of the openings for the attachment of locations A1 and C1 (their height from the
surface), take the surface inclination into account. This way you will ensure the same passage height
on both sides of the pergola and the flatness of the perimeter section
.
B.2 Take measurements of the anchoring points for the installation of the pole A3 and pole C3.
Then proceed in accordance with items
A.1 through A.4 above.
B.3 Insert the perimeter section A1A3 to the pre-installed pole A3 and press it against the wall mounting
point A1. Do not hold the perimeter section by the eaves part only
– hold it by the main supporting
section. Otherwise, eaves will likely be damaged. Prior to installing, apply sealing compound to the
perimeter section, see Fig. D.3.
B.4 Use a suitable anchoring system to fasten to attach the perimeter section A1A3 to the wall at A1. Pay
special attention to alignment and positioning during this operation.
Then proceed in accordance with items
A.8 through A.14 .
B.5 Measure the placement of the end section at the building wall with the last slat closed, so that the slat
fully shuts into the section. Install the end section and apply polymer
– or polyurethane-based caulk (1)
to its rear and upper sides.
B.6 Measure the placement of the cover section (4) above the points A1-C1 of the pergola. Prior to
installing, apply compression tape (2) to its rear side. We recommend a 15 mm tape with the 5
– 15 mm
compression. Attach the cover section to the façade using bolts with packing rubber (3). Apply
polymer- or polyurethane-based caulk (1) to the upper edge of the cover section.
Then proceed in accordance with items A.15 through A.20