3A
Troubleshooting
•
If the unit is not functional
–
check main power supply is
‘
on
’
and check fuses.
•
If the unit is functional but lamp does not light - lamp may require replacing.
•
If the unit is not moving to the music check the sound-activation adjustment (when
applicable)
•
If after trying these solutions you still have a problem contact your dealer for technical
assistance.
•
The unit is built-in thermal switch, the lamp will not working when the internal temperature is
above 80
0
C, and the lamp will working when the internal temperature is cool down.
Caution
•
Do not obstruct the air vents.
•
Do not touch unit while hot.
•
No user serviceable parts inside please refer to the nearest authorized technical assistance
office for service.
Power Connections
The unit is supplied with a power plug appropriate to its voltage and destination. Should any
other connections be required they must be carried out with the following configuration.
Earth = Green/Yellow cable
Neutral = Blue cable
Live = Brown cable
In the USA & Europe, it is required that all plugs are 3-pin type i.e. with Earth/Ground
connection.
In the UK, it is required that all mains plugs are fitted with 13A fuses.
How To Control The Unit
A. Slave Unit only
This fixture is designed to operate as a stand-alone unit, the strobe speed is adjustable. It can
be controlled by strobe controllers, like BF-01C, BF-04C, BF-04A., etc. One can link the slave
unit with the Master Unit for an active pre-programmed strobe show ( Please refer to I Beat
System below.)
B. I Beat System
This system is designed to operate under master/slave link. There is a great built-in programs
in the master unit and can be triggered by music. By linking the units in master/slave
connection, the first ( master ) unit will control the other units to give an automatic sound
activated synchronized light show. This function is good when you want an instant show. Just
plug in and play for immediate operation.
Master Slave 1 Slave 2 Slave 3
By Easy Controller
The easy remote control is used only in master/slave mode. By
connecting to the 1/4
”
microphone jack of the first unit, you will find
that the remote control on the first unit will control all the other units
for Stand by, Full on/Next/Speed and Audio/Manual /Auto function.
-- STAND BY
: stand by and blackout all the unit.
-- FULL ON / NEXT / SPEED
:
•
Under Audio status ( LED light off ), hold on the FULL ON button, all
the units will strobe quickly.
•
Under Manual status ( LED light on ), choose next pattern, triggered
by music, by press the button NEXT.
•
Under Auto status ( LED light blinking ), press SPEED button briefly
to choose the patterns ( 12 patterns vary with different speeds- fast,
normal, or slow ), the patterns will run in a loop.
-- AUDIO / MANUAL / AUTO
:
•
AUDIO status ( LED light off ): All patterns triggered by music.
•
MANUAL status ( LED light on ): Press button Next to choose the next pattern triggered by
music.
•
AUTO status ( LED light blinking ): Press button Speed to choose patterns varied
with
speed.
