Iso-Tech IDM-8341 Series, Быстрый старт

Страница: 4 / 32

Safety Guidelines
General Guideline
CAUTION
•
Make sure that the voltage input level does not
exceed DC1000V/AC750V.
•
Make sure the current input level does not exceed
12A.
•
Do not place any heavy object on the instrument.
•
Avoid severe impact or rough handling that can
lead to damaging the instrument.
•
Do not discharge static electricity to the
instrument.
•
Use only mating connectors, not bare wires, for
the terminals.
•
Do not block or obstruct the cooling fan vent
opening.
•
Do not perform measurement at the source of a
low-voltage installation or at building installations
(Note below).
•
Do not disassemble the instrument unless you are
qualified as service personnel.
•
Make sure that the COM terminal to earth is
limited to 500Vpk.
(Note) EN 61010-1:2010 specifies the measurement
categories and their requirements as follows. The
IDM-8341/ 8342 falls under category II 600V.
•
Measurement category IV is for measurement
performed at the source of low-voltage installation.
•
Measurement category III is for measurement
performed in the building installation.
•
Measurement category II is for measurement
performed on the circuits directly connected to the
low voltage installation.