DMP116it | 1
st
Issue rev. a | 03/2022
pag.
MVC503R-MB Configuration Tool
–
Product Manual
16
while a value of 120% indicates that the actuator is performing the initial
position/calibration. The current feedback value is read by the software at the
start-
up and cyclically every 1.5sec (it’s possible to read the value clicking on the
label “Feedback”).
The textbox
“Flow Rate PICV” is N.A.
•
Flow Rate PICV:
in case of “LIBRA” valve selection the percentag
e of the flow rate
valve is shown, while the textbox “Feedback” shows N.A.
3.8
“
Configuration File
”
Menu
This menu allows to save a .csv file useful for saving the configuration of an actuator
and repeating it later on the same or on others actuators present.
In the drop-down menu are present the following items:
•
Load configuration file
•
Write configuration file
•
Read configuration file
•
Load configuration file:
it saves into the actuator the parameters collected into
the selected CSV file (make sure a valid connection is open by pressing the
“CONNECT” button before loading a new configuration).
•
Read configuration file:
it allows to select a configuration file and to show all
the parameters in the proper textboxes.
•
Write configuration file:
it allows to save the configuration file (CSV) containing
all the configuration parameters.
Read and Write option can be done off-line (no Modbus connection is necessary).
