Islandaire 6041228, Инструкция по установке и эксплуатации

Страница: 13 / 24

Technician Setup Menu
This thermostat has a technician setup menu for easy installer configuration. To set up the
thermostat for your particular application:
1. Press the Menu button.
2. Press and hold the Tech Set button for three seconds. This three second delay is
designed so that homeowners do not accidentally access the installer settings.
3. Configure the installer options as desired using the table below. Use the “+” and “-” keys
to change settings and to move from one step to another. Note : Press the Done key to
exit Tech Setup Menu.
Tech Setup Steps LCD Will Show Adjustment Options Default
Filter Change
Reminder
This feature will flash
a reminder after the
elapsed run time to
remind the user to
change the filter. A
setting of “OFF” will
disable this function.
You can adjust the
filter change reminder
from “OFF” to 2000
hours of fan runtime
in 50 hour increments.
Room
Temperature
Calibration
This feature allows the
installer to change the
calibration of the room
temperature display.
For example, if the
thermostat reads 70°
and you would like it to
read 72°, then select 2.
°F
You can adjust the
room temperature
display to read up to
3˚ above or below
the factory calibrated
reading.
°F
Minimum
Compressor
On Time
This feature allows the
installer to select the
minimum run time
for the compressor.
For example, a setting
of 4 will force the
compressor to run for
at least 4 minutes every
time the compressor
turns on, regardless of
the room temperature.
Min Com On
You can set the
minimum compressor
run time to “OFF”, “3”,
“4”, or “5” minutes. If
3, 4, or 5 is selected,
the compressor will
run for at least the
selected time before
turning off.
Min Com On
11
Technician Setup