Iseo ACE IS9100, Инструкция по монтажу

Страница: 3 / 24

IS9100
—
ACE
3 ISEO
1. Preparation of operators
Put the operator onto the ground or a table to prepare it
Remove the PCB with the internal program switches from
both operators.
First remove the connection cable
➀
, then move the PCB
upwards and pull it out
②
.
Remove the mains switch from the operator that is not
installed at the side where the power supply is connected.
Push the 3 brackets inwards in order to remove
the connection unit
➀
.
Open the two covers above the mains supply PCB
②③
and
remove the connectors.
Pull out the mains supply PCB
④
.
Close both covers and reconnect the connection unit.
1
2
3.
4.
1.
2.
3
2
1