The
INHIBIT
signal must be applied for at least 100 ms to guarantee a detection. When the INHIBIT is no longer active, the
INHIBIT flag must be reset before the voltage can be switched ON again.
4.3 IHD - Detector INHIBIT
The option IHD is a special version of a single channel INHIBIT to be connected to the HV INHIBIT outputs of
detectors/preamplifiers from Ortec and Canberra. In order to enable the HV generation either a positive voltage signal
(Canberra) or a negative signal (ORTEC) must be applied. The INHIBIT signals are connected via BNC connector (one for
each channel) located on the backplane of the module.
4.4 L – Lower output current (HP only)
The output current is limited to a lower value, e.g. 100 µA.
4.5 T10 – Lower temperature coefficient (HP only)
Improved temperature coefficient of 10ppm/K
5 Dimensional drawings
- to be continued -
Figure 1: Dimensional drawings
SHR – Desktop High Voltage Power Supply | Last changed on: 19.01.2018 |
www.iseg-hv.com
9/11