11.3. Hardware
In the hardware section, all iCS connected devices like connected crates, controllers and modules are listed and configurable.
Each device is represented by a tab, modules and controllers are nested into their responding crates. The CAN lines of the crates
are presented with a yellow or green upper tab border (corresponding to yellow or green CAN line), master crates and modules
in legacy crates with a blue upper tab border.
The configuration is stored independently from the current hardware setup or connected states. This gives the opportunity to
detect misconfigurations and recent hardware setups can easily be restored.
To apply the complete detected hardware state into the configuration use the „
AUTO CONFIGURATION
“ button
after triggering
a rescan using the
„
RESCAN HARDWARE
“
button
.
To apply the detected config of just one device (controller or module) use the „
APPLY CONFIG
“ button under each single tab. The
devices information is stored with the information of „module/device config“ column. Here the line and address ID are shown
and a serial number can be entered (or applied by using auto configuration / apply). If the model of the hardware device could be
detected automatically, a model is selected in the dropdown list, otherwise it should be selected manually. Here a “
FIND
” buttons
checks the list and helps prefiltering the list.
Crate Controller CC24/CC23 | Last change on: 14.04.2020 |
www.iseg-hv.com
24/44
