4 of 8
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Adjust Frameset to Width of Worksurface
Adjust the width of the Frame assembly
to fit the worksurface by sliding the two
halves outward.
Position to leave at least .5" of the
worksurface width on each end beyond
the frame width and 5.75" from the back
of the Worksurface to the back of the
Frame.
Mark the position of the eleven mounting
holes on the bottom of the worksurface.
CAREFULLY drill pilot holes at the eleven
locations.
Do not drill all the way
through your worksurface!
Attach Frame Set to Worksurface
Double-check that the desk base is properly
positioned over the pilot holes.
Attach the desk base to the underside of the
desktop using seven #12 × 3/4" Phillips Head
Wood Screws (O).
.5"
minimum
.5"
minimum
5.75"
5.75"
½"
at least 1"
mark
.5"
minimum
.5"
minimum
5.75"
5.75"
½"
at least 1"
mark
.5"
minimum
.5"
minimum
5.75"
5.75"
½"
at least 1"
mark
3
4
O
O
#12 × 3/4" Phillips Head
Wood Screw
Hardware at actual size
Double-check that the wood screws
are not too long for your desktop
and won’t puncture the surface
when screwed all the way in.
DO NOT DRILL ALL THE WAY THROUGH THE WORKSURFACE!
You may want to mark your drill bit so that you do not drill all
the way through your worksurface! These instructions and the
hardware included assume that you are using a standard 1" thick
worksurface. If you have a worksurface that is thinner than 1", you
will need to use different fasteners to attach your frame.
a
a
a
b
b
b
b
b
c
d
d
c
