ise smart connect KNX Hue
Configuration
Order No. 1-0002-003
Product Manual Page 18 (60)
5
Configuration
Configuration of the ise smart connect KNX Hue is divided into the following steps:
Preparations:
For explana-
tions, see
1
Mount device, connect it to KNX bus connection and auxiliary voltage.
Chapter 4
2
Set up the Hue lights using the Philips Hue software.
Philips Hue
documentation
3
Install the ise smart connect KNX Hue on the same IP network as the Philips
Hue Bridge and make settings in the router of the IP network if necessary.
Configuration via ETS:
After installing the device and connecting the bus, power supply and Ethernet, the device can be
commissioned. The preparatory configuration is carried out using the Engineering Tool Software,
ETS, available from the KNX Association, see
1
Create the ise smart connect KNX Hue as a device in the ETS.
Section 5.1
2
Assign physical address as usual corresponding to the KNX topology.
3
Set IP address, IP subnet mask and standard gateway address for the ise
smart connect KNX Hue or select
Obtain an IP address automatically (from a
DHCP server)
.
Section 5.3
4
General parameters for setting the ise smart connect KNX Hue.
Section 5.4.1
5
Connect group addresses to group objects as usual.
Section 5.4.3
Section 5.4.4
6
The ise smart connect KNX Hue is now ready to start up
by pressing
Programme ETS
; then test functions.
7
Register the ise smart connect KXN Hue on one or several Hue Bridges and
assign the Hue lights to the KNX communication objects on the device web-
site
Section 6.9
Section 6.10
