IRTrans Ethernet PoE, Руководство по оборудованию

Страница: 15 / 16

Hardware Guide
Ethernet - Ethernet PoE
© 2012 IRTrans GmbH
15
9. Reset to factory defaults
If it should become neccessary to reset the IRTrans to factory defaults (e.g. the
password has been lost) this can be accomplished as follows:
Remove power from the device and open the case.
Resetting the IRTrans will be done by shorting pins 5-6 of the 6 pin header inside
the device:
After putting a jumper on pins 5 and 6 power up the device and wait a few se-
conds. The status LED will flash green-red once. Now remove power again and
remove the jumper. The IRTrans is reset to factory defaults.
6-pin header