Unpack & Inspect
1
You should have:
• 1 Radiator
• 1 Airvent (pre-fitted) (B)
• 1 Blanking Plug (pre-fitted) (C)
• 1 Diverter (pre-fitted) (D)
• 4 Bracket Caps (L)
• 4 Bracket Screws (I)
• 4 Brackets (H)
• 4 Support Plates (G)
• 8 Wall Plugs and Screws (F+E)
Contents
2
Mark and Fix Brackets
4
Diagrams of Ovali
The Radiator Company prides itself on selecting products from
manufacturers who exercise tight quality control measures. We only
select models with excellent standards of welding and brazing, as well
as high quality finishes. All of our products are well packaged and
should reach you in perfect condition. Just in case however, we offer
a minimum 5-year no quibble guarantee for all
radiators and towel rails.
The Radiator Company must be notified of any
shortages or damage within 28 days of delivery.
For further information please see terms and
conditions on back page.
PLEASE NOTE :
It is essential that all brackets are level to ensure a
vertical alignment for connecting the pipework.
Pipe Centres
Pipe centres left to right
Pipe centres from wall
Depth from wall
Commission
5
Please Note:
In accordance with Part L1 2006 of the Building Regulations and
BS7593:1992 code of practice for the treatment of hot water and
central heating systems, we strongly recommend flushing the heating
system post installation of new radiators and then adding the correct
quantity and type of inhibitor for use with your radiator and system
to prevent corrosion. Damage caused to systems not protected by
a suitable inhibitor will not be covered by manufacturer’s guarantee.
Width + Valves
36mm
124mm
36
124
1. The airvent “B” and the blanking plug “C” are already fitted on
the radiator.
2. The Diverter “D” and blanking plug “C” are already installed
on the lower collector in the radiator. Please Note: The diverter is
identified by the Yellow Cap “M”. If you would like to move change
the position of the Diverter please see section ‘3’.
3. Accurately mark bracket holes on the wall using a tape measure
and
spirit level. (Height of the radiator from floor : minimum 100mm)
4. Drill 8mm diameter holes to a minimum depth of 50 mm,
and insert wall plugs “E”.
5. Place the support plates “G” on the wall in line with the wall plugs
and secure using screws “F”
6. Insert the brackets “H” into the support plates “G”, and secure
and level with screws “I”. Fit the bracket closing cap “L” on top.
7. Hang the radiator on the first space of the brackets (please see
diagram above) and ensure the radiator is level using a spirit level.
Please refer to diagrams opposite when following steps below:
You will need:
• Tape measure
• Electric drill and bits
• Spirit level
• Flathead screwdriver
• Crosshead screwdriver
Please Note: The wall plugs and screws supplied will not be
suitable for all wall types. Please ensure suitable wall plugs and
screws are used.
Identifying the Diverter
3
The pre-fitted diverter is marked with a yellow cap on the left hand side
of the bottom collector. If the diverter needs to moved, firstly unscrew
the diverter “D” on the left hand side, and the blanking plug “C” on the
right hand side of the bottom collector. (Please see diagram opposite)
Swap these round so that the Diverter “D” is now on the right hand side,
and the Blanking Plug “C” is on the left, then screw in securely.
A
c
D
c
M
E
F
G
L
b
H
I
Place brackets on the outside
holes for maximum support
