Optimizing Irrigation . . . Maximizing Conservation . . . Worldwide Since 1951
1425 Palmyrita Ave., Riverside, CA 92507
951-682-9505 •
FAX
951-682-9501
www.IRROMETER.com
WARRANT Y:
The IRROMETER COMPANY warrants its products against defective workmanship or materials under
normal use for one year from date of purchase. Defective parts will be replaced at no charge for either labor or parts if
returned to the manufacturer during the warranty period. The seller’s or manufacturer’s only obligation shall be to replace
the defective part and neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential,
arising out of the use of or inability to use the product. This warranty does not protect against abuse, shipping damage,
neglect, tampering or vandalism, freezing or other damage whether intentionally or inadvertently caused by the user.
(10.16) #745
LITHO U
.
S
.
A
.
US Patent D672712,
US and International Patent Pending.
Contains Transmitter Module FCC ID:
0A3MRF89XAM9A
Contains Transmitter Module IC: 7693A-89XAM9A
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment OFF
and ON, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a separation distance
of 20cm or more should be maintained between antenna of this device and persons during operation. To ensure
compliance, operation at closer than this distance is not recommended. The antenna(s) used for this transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference, including
interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
EN 55022 Class A
EN 55024/IEC 61000-4-2: Electrostatic Discharge
EN 55024/IEC 61000-4-3: Radiated Immunity
Contains Transmitter Module:
7693A-89XAM8A
Conforms to the following ETSI standards:
– EN 300 220-2 V2.3.1 (2001-02)
– EN 301 489-3 V1.4.1 (2002-08)
REGULATORY APPROVAL IN US AND CANADA
REGULATORY APPROVAL EUROPEAN UNION
®
Содержание IRROmesh
Страница 11: ...Notes or System Layout Diagram 11...