Programmable Hose Thread Watering Timer IT-NTT & IT-NTT-R
Innovative tap timer for garden watering and micro/drip irrigation systems
This newly designed hose end irrigation timer is powered by battery and features
easy to program dial settings. The solenoid valve control provides improved
performance and increased reliability for home garden hose and drip irrigation
systems. Timer IT-NTT-R is specifically designed to be compatible with the majority
of the wired rain sensors currently available in the market.
Key Features
Connects to 3/4" Hose Bib or Y Ball Valve
Inlet: 3/4" FHT (Female Hose Thread)
Outlet 3/4" MHT (Male Hose Thread)
Powered by one 9V Alkaline Battery
12 Frequency and Duration settings provide customized combinations
Both Programmed and Manual Watering Options are available
Low Battery Indicator
Start Time delay function up to 12 hours
Max. & Min. operating pressure: 1,0-8,0 Bar
Max. & Min. operating flow rate: 20 l/h-19 l/min
Product Size: 12x10x8 cm (H x L x W)
* Rain Sensor function is only on version IT-NTT-R
1.
install one 9V ALKALINE battery. After battery installation, check the case for
correct alignment and fasten the screws. Please keep the battery compartment
dry when changing the battery.
2.
Test the timer with the battery installed. Simply turn the “DURATION” knob
to “ON” position and the indicator will flash “Green” one time. If the battery
power is low, the indicator will continuously flash “Red” until the battery is
completely drained.
3.
It is recommended to program the timer prior to connecting to the tap.
Refer to “How to Program”
4.
Holding the unit steady, hand tighten the tap connector onto the faucet/tap until
it is secure. Do not use a wrench or pliers and avoid over tightening. Please
confirm the size of the connections (3/4” or 1”) before installation; using an
adapter if needed.
How to Program
Once the battery is installed into the timer, simply determine your watering
frequency and duration, and then turn the knob to the appropriate position.
How to Set the Watering FREQUENCY
Turn the knob to the desired frequency. Whenever the knob is turned to the new
setting for 2 secs, the frequency resets to the new setting. The frequency options:
1) By hour(s): 1,2,3,4,6,8,12,24,48,72
2) By week: WEEK (once per week)
*Frequency setting must be longer than duration setting.
How to Set the Watering DURATION
Turn the knob to the desired duration. The water will be controlled by the frequency
and duration settings, and then close automatically. The duration options:
Frequency
Start Delay
Duration
Rain Sensor
Indicator
3/4” tap connector
Battery Compartment
