Foot Strainer
Water Level Sensor
Water Outlet Tube & Filter
Anti-Siphon Device
The water level sensor should be secured so that the
higher probe is at least 3cm higher than the water inlet.
Secure it using cable ties.
During operation, if one of the sensors is out of the water
the pump will stop and the beeper will sound. If the beeper
is a nuisance it can be silenced by unplugging it from the
circuit board.
The water level sensor comes with a 5m cable – this can
be extended by purchasing an extension lead.
To protect the drippers from debris, there is a fine mesh
filter. This can be fitted on either side of the pump, (fig 2)
but a valve must be fitted between it and the tank to turn
off the water flow while cleaning. (Valve 3 in fig 1).
The anti-siphon is needed to stop the water flow when the
pump has stopped if the first emitter is lower than top of
the water source. It should be fitted in the delivery tube
to the emitters, (it is number 8 in fig1). It can be fitted by
making a hole with the punch provided and pushing the
blue part of the anti-siphon directly into the tube, threaded
end first. Anti-siphon device must be fitted higher than
the water source.
Standard Pump
Top entry
Vertical
Resting on tank bottom (see fig 4)
5
Figure 4
Figure 5
