Place a Shelf (G) on a clean, carpeted surface as shown. Insert the Metal Rafix Cams (H1)
into the Shelf with the flat edge facing outwards and tap until fully seated in place as
shown. Insert Metal Rafix Cams into the other Shelf in the same manner.
Important!
The flat edge of the Rafix Cam must be aligned with shelf edge. Rafix Cams
can not be repositioned if installed incorrectly.
#1
NOTE: Both the MCH42 and MCH48 Modular Corner Hutches assemble in a similar
manner. For convenience, only the MCH48 is depicted in the following instructions.
MCH42
MCH48
H1
H1
H1
H1
H1
H1
H1
H1
G
G
ASSEMBLED
DISASSEMBLED
Using the Minifix System:
Insert the Minifix Cams into the
appropriate holes with the arrow
facing outwards as shown.
Using the #2 Phillips screwdriver,
rotate the Cam Devices a half turn
clockwise until snug.
To disassemble, turn the Cam
Devices counter-clockwise and
remove panels.
When screwing post into hole,
Do
Not
over tighten. Screw post down
until bottom face of post flange just
touches board surface.
MCH42
(7 Rafix Cams)
MCH42
(8 Rafix Cams)
