Page 6 of 10
⚠
CAUTION
CAMERA USE AND CARE
Do not force the cameras. Products are safer and do a better job when used in the manner for
which they are designed. Plan your work, and use the correct products for the job.
Check for damaged parts before each use. Carefully check that the cameras will operate properly
and perform intended functions. Replace damaged or worn parts immediately. Never operate the
cameras with damaged parts.
Do not use cameras with malfunctioning switches. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
Store the cameras when not in use. Store in a dry, secure place out of the reach of children.
Inspect the cameras for good working condition prior to storage and before re-use.
Use only accessories that are recommended by the manufacturer for use with your cameras.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Keep guards in place and in working order. Never operate the products without the guards in
place.
Mounting Instructions
⚠
WARNING
Do not use in wet locations.
Intended for indoor use only.
Select a location for the decoy camera that is easily visible by potential intruders, but out of reach.
Point decoy camera and LED towards the area of concern so that the flashing light is easily
visible.
Select the position for the camera and drill holes for the anchors using the paper template
provided. (Screws and anchors are supplied. Use an appropriate screw type for the mounting
surface.)
Install batteries according to "+ /- polarity marker". Insert the two AA batteries into the battery
compartment.
Do not tighten screws completely so you can attach the camera base through the keyhole slots.
Fit camera body keyhole slots to the screws. Slide camera onto screws and rotate camera to lock
into keyhole slots.
Note: If camera is loose, adjust depth of screws until camera fits snugly.
Position camera front with flashing LED so that it is easily visible.