Page of 17
2
Thank you very much for choosing an IRONTON product! For future reference, please complete
the owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
This machine is designed for certain applications only. The distributor cannot be responsible for
issues arising from modification. We strongly recommend this machine not be modified and/or
used for any application other than that for which it was designed. If you have any questions
relative to a particular application, DO NOT use the machine until you have first contacted the
distributor to determine if it can or should be performed on the product.
For technical questions please call
1-800-222-5381
.
INTENDED USE
The circular saw is for cross cutting, rip cutting, bevel cutting and pocket cutting all types of wood
products.
SPECIFICATIONS
•
Item#: ------------------------------------ 46462
•
Rated Power: -------------------------- 120V AC, 60 Hz, 15.0 Amp
•
No-Load Speed: ---------------------- 5500 RPM
•
Blade Size: ----------------------------- 7-1/4” (185 mm)
•
Arbor Size: ----------------------------- 5/8”
•
Cutting Capacity at 90°: ------------ 2-1/2” (63mm)
•
Cutting Capacity at 45°: ------------ 1-15/16” (49mm)
Includes: Saw, 24T Carbide-Tipped Blade (Assembled), Rip Fence, and Hex Key for Blade
GENERAL SAFETY RULES
WARNING
:
Read and understand all instructions. Failure to follow all instructions
listed below may result in serious injury.
CAUTION:
Do not allow persons to operate or assemble this saw until they have
read this manual and have developed a thorough understanding of how the saw works.
WARNING:
The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions or situations that could occur. It must be
understood by the operator that common sense and caution are factors that cannot be built
into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS