Page of 4
2
Thank you very much for choosing an Ironton product! For future reference, please complete the
owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to
become familiar with this product before you begin using it.
This jack is designed for certain applications only. The distributor cannot be responsible for issues
arising from modification. We strongly recommend this jack not be modified and/or used for any
application other than that for which it was designed. If you have any questions relative to a particular
application, DO NOT use the jack until you have first contacted the distributor to determine if it can or
should be performed on the product.
For technical questions please call
1-800-222-5381
.
INTENDED USE
This marine swivel jack with sturdy 2¹⁄
₄
" tube is reliable and very easy to use. The sidewind internal
gear design with large, grooved comfort handle makes cranking easy, while a deep-seated snap ring
adds side load capacity. A durable 1/2" pull pin activates the swivel mechanism, allowing you to swing
the jack up and out of the way when not in use.
Item#
Lift Capacity
Finish
Range
44061
1000 lbs.
Zinc
10.5in.
–22.75in.
44062
1000 lbs.
Zinc
10.5in.
–22.75in.
44063
1000 lbs.
Black
10.5in.
–22.75in.
GENERAL SAFETY RULES
WARNING
Read and understand all instructions. Failure to follow all instructions listed below may result in
serious injury.
Owner must ensure that the jack is installed according to these instructions
Never position any part of body under this product or supported load.
Fully retract/rotate jack before towing.
This jack is not intended for use as a transport device. Minimize movement of the implement
while the jack is under load.
Do not allow children to play on or around this jack while supporting a load.
Secure the load, vehicle and trailer form rolling when operating jack.
Never attempt to lift or support loads in excess of the rated strength of this trailer jack.
This jack is designed for vertical loading. Excessive side forces may cause failure and or injury.
Before moving trailer crank jack to its lowest position.
These jacks are not designed for round tongues.
Do not weld bolt-on brackets or strap to the tongue.
Do not modify the jack in any way. Unauthorized modification may impair the function and/or
safety and could affect the life of the equipment. There are specific applications for which the
jack was designed.
The swivel is very strong. However abuse, corrosion or damage may cause swivel to break.
Regularly inspect the swivel for damage and discontinue use if the swivel is damaged.
