The Arlec WLED40, 16W LED Worklight is suitable for indoor or temporary outdoor used. The worklight can be
plugged into a standard power point and has a weather proof classification of IP44.
inTRODUcTiOn
2
3
aSSeMBlY
USe OF WORKliGhT
Carry
Handle
Support
bracket
H Base
Stand
Assemble the worklight as shown in the figure. Fix the support bracket of lamp head onto the base
stand with 2 self threaded bolts and nuts supplied. Ensure that the nuts are tight and firmly holds the
support bracket and base stand assembly together.
To adjust the tilt of the lamp head, loosen the moulded knob attached at the end of the support bracket
and with the help of the carry handle tilt the lamp head to a desired angle. Once the desired angle is
achieved tighten the moulded knobs to hold the lamp head in position.
Note:
Do not remove the support bracket from the lantern body.
While adjusting the lamp head avoid pinching or bending of the supply cord.
1. To operate plug the worklight into a standard power point.
2. Adjust the tilt of lamp head to a desired angle.
3. Press the power on switch located on the terminal housing
cover at the rear of the housing to ON position.
WArNiNg
When the luminaire is operated outdoors the supply cord must be appropriately covered or located
such that it is subjected to indoor conditions only.
If the external flexible cord of this luminaire is damaged, contact the Arlec Customer Service team.
(Refer to details on back page) or similar qualified person in order to avoid hazard.
Easy Grip Locking Nuts
Sealed dust proof
ON/OFF switch
1.8m power cord
importANt NotES:
Do not open the worklight body, no user serviceable parts inside.
Do not immerse in water or other liquid.
Do not use abrasive cleaners, clean with damp cloth
• 16 Watts LED array (40 LED modules)
• Provides high intensity even
light distribution
• Indoor / Outdoor lighting for Contractor,
Tradesman, & DIY Applications
• Cool to touch durable diecast
aluminium housing
• Wide angle coverage for large work areas
• Weatherproof rating IP44
120º
even
light
beam
hiGh OUTpUT leD MODUle aRRaY
WLED40_Instructions.indd 3-4
13/03/12 4:52 PM
