7. ATTACH CABINET TO STUDS
Using the pre-drilled holes in top
of cabinet, attach unit to studs
with two #10 x 1
1/2
” screws for top
installation.
Example shown with studs
to illustrate mounting.
6. INSTALL UNIT IN WALL
Begin installation by carefully lifting unit
into the wall opening. Make sure the
cabinet is plumb and level. If needed,
add shims to help unit fit snug in place.
Ensure that power is
disconnected at service
entrance before proceeding.
4. REMOVE ELECTRICAL KNOCKOUT
Open the front cover of the raceway
by removing the screw at the top and
bottom of the raceway.
Locate the electrical knockout, as
specified on diagram provided.
Install a 3/8” romex connector where
the knockout was removed.
2
1/2”
2
1/4”
1
1/4
”
DIA. VENT
HOLE FOR
WIREWAY
DOOR
CABINET
EXTERIOR
5. INSTALL ELECTRICAL WIRING
Verify that there is ample supply wire
available to run from the top of the
ironing center to the approximate
location of electrical pigtails.
Note: A free wire length of 48” is
recommended.
Begin to place the ironing center into
its location while feeding the supply
wire through electrical knockout, and
the 3/8” romex connector through the
back of the raceway.
Содержание UD-42
Страница 1: ...Installation Manual MODEL UD 42 ...