INSTALLATION & ADJUSTMENT
Electrical and electronic equipment, batteries, battery chargers and
equipment housings, at the end of their life should be disposed of sepa-
rately from your household waste. Please dispose of all components
correctly at your local waste collection / recycling centre
.
Declaration of Conformity
Model Number: IM-DCS-01
Trade Name: Iris Marine
Responsible party: Iris Innovations Limited
Address: Sailmakers Loft, Kingscopse Farm, Tanhouse
Lane, Botley, Southampton SO30 2SZ. United Kingdom.
Telephone: +44(0)1489 798484
This device complies with Part 15 of the FCC Rules. Op-
eration is subject to the following rules:
(1) this device may cause harmful interference, and
(2) this device must accept any interference received, in-
cluding interference that may cause undesired operation.
Before using your camera please read and understand these
safety instructions.
Warning:
This product contains chemicals known to the state of California to cause cancer,
birth defects or other reproductive harm. Wash hands after handling.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions may cause harmful in-
terference to radio communications. If this equipment does cause interference to
radio or television reception the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
Reorientate or relocate the receiving antenna.
Increase the separation between the equipment and transmitting / receiving de-
vice.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult your dealer or a qualified CCTV engineer for help.
Iris Innovations Limited
Unit 9 Swanwick Business Park.
Bridge Road, Swanwick, Hampshire SO31 7GB
United Kingdom
Tel/Fax: +44(0)1489 570797
email: [email protected]
web: www.boat-cameras.om
1. Site camera appropriately, ensuring yourdrill
holes will not foul any other cabling or equipment.
Before making any permanent fixings it is advised
that the camera is offered into position, powered
up and the camera modules are adjusted to
acheive the desired views
2. When the housing position has been ascer-
tained mark the four fixing holes and central cable
hole through the base unit.
3. If drilling through gel coat, take care not to splin-
ter when drilling. Drill a pilot hole then very care-
fully drill out the 4 fixing holes in accordance with
your fixings. Use a 6mm drill for the cable entry
hole.
4. Carefully screw camera base to surface taking
care not to crack the gel coat as the screws are
tightened.
5. Adjust camera modules by loosening the brack-
ets with a 2mm hex key. Position the modules are
desired, checking the image on your screen then
fully tighten the hex screws to lock modules in
place.
6. Replace lens cover and top cover. It is recom-
mended that a bead of silicone grease be applied
to the top of the gasket that runs around the cam-
era base. Screw down tightly with 6 x M3 x 6mm
hex screws supplied.
7. Connect camera video and 12vdc power to the
camera cable tail.
Содержание IM-DCS-01
Страница 1: ...IM DCS 01 USER GUIDE ...
