iReliev Plus Pain Relief & Recovery ET-8080, Инструкция по эксплуатации

Страница: 12 / 36

www.iReliev.com
12
CH1 CH2
STEP BY STEP OPERATION GUIDE FOR TREATMENT
STEP 1 - Preparing Your Skin Before Using
Following the steps below can help prepare the skin for optimal electrical dispersion and increased stimulation
sensitivity:
1. Determine the electrode pad placement sites for the electrode pad(s).
2. Wash the area with mild soap and water (do not use alcohol). Rinse and dry thoroughly.
3. Trim excess body hair from the area with scissors (do not shave).
4. If desired, apply iReliev® Conductive Gel or Conductive Ion Spray to help increase
conductivity. This may also reduce the chance of skin irritation and may extend the life of the electrode pads.
5. When removing electrode pads, always remove by pulling in the direction of hair growth.
6. It may be helpful to apply iReliev® Conductive Gel or lotion on electrode pad placement area when system is not
in use to help increase moisture of skin.
STEP 2 - Connect Lead Wire(s) to Channel 1 (CH1) and to Channel 2 (CH2)
Insert one lead wire into each desired channel.
Note: Fully insert lead wire(s) into respective channel socket(s). This will ensure the safety
feature intensity level reset is not activated.
Note: The device will auto-reset by default to “0” Intensity Level on the respective channel if
the lead wire is not fully inserted.
STEP 3 - Connect Electrode Pads to Lead Wire(s)
Connect lead wire pins to 2 small or 1 large electrode pad per channel, before applying to the skin. System requires that
there is a minimum of 2 small electrode pads or 1 large electrode pad per lead wire .
Note: The device will auto-reset by default to “0” Intensity Level on the respective channel if the lead wire is not fully
inserted into the device and/or electrode pad and placed on your skin.