ircon Modline 5, Руководство по эксплуатации

Страница: 106 / 156

Operation
104
Rev. L6 Feb 2017
Modline 5
Laser I IN Operation
When Laser I IN operation is selected, remote current input of Emissivity and E-Slope is not operational.
The required SPST switch can be an actual toggle or a press and hold type switch that would de-energize
the laser when released.
I IN Operation - Condition Set One
1.A If Sensor is powered up with I IN current applied (remote switch closed), the Laser will not operate
until the remote switch is opened and then closed again. The Laser will only operate with switch closed.
1.B When the Laser is energized by closing the remote switch, the laser can be de-energized with a RS-
485 Command, the Rear Panel Laser Switch or by disconnecting I IN current (remote switch open). If
none of these occur, the Laser de-energizes after the 20 minute time out period.
1.C If Laser has been de-energized by a RS485 Command, the Rear Panel Laser Switch or the 20 minute
timeout period, the I-In current must be disconnected (switch open) and re-applied (switch closed) to
energize the Laser with the remote switch. However, the laser can be activated with the Sensor Rear
Panel Laser switch or RS485 command without opening and closing the switch.
1.D The Laser can be energized by the Rear Panel Laser Switch or a RS485 command only when the
remote switch is closed and condition 1A has been satisfied.
PkHd Switch Operation
When Laser PkHd switch operation is selected, remote switch Reset of the peak picker, and, the Track
and Hold function are not operational. The SPST switch can be an actual toggle or a press and hold type
switch which would de-energize the laser when released. The Peak Picker can be reset at the Sensor
Rear or with a RS-485 command.
Condition Set Two
2.A If Sensor is powered up with the PkHd switch closed, the Laser will not operate until the switch is
opened and then closed again. Laser will only operate with PkHd switch closed.
2.B When the Laser is energized with a PkHd switch closure, the laser can be de-energized with the
Rear Panel Laser Switch, a RS-485 Command, or by opening the PkHd switch. If none of these occur,
the Laser de-energizes after the 20 minute time out period.
2.C If the Laser has been de-energized by a RS485 Command, the Rear Panel Laser Switch or the 20
minute timeout period, the PkHd switch must be opened then closed to energize the Laser with the
PkHd switch. However, the laser can be activated with the Rear Panel or RS485 command without
opening and closing the switch.
2.D The Laser can be energized by the Rear Panel Laser Switch or a RS485 command only when the
PkHd switch is closed and condition 2.A has been met.
PkHd Switch wiring
The switch is wired directly across the PkHd Switch terminals on the TSP Terminal Strip Plate or the
POI Power Supply/Signal Interface Box.
5.12 Out of Range Displays and Error Codes
The Modline 5 displays word messages on its rear panel display to indicate Sensor diagnostic results.
Below are explanations of the reported measurement status and error codes.