25
CONTROL CABLE ADJUSTMENT
The control cables are adjusted by screw adjustments at the cable ends.
With the control levers released:
•
for the clutch a play at the clutch lever end should be equal to 5 - 8 mm/0.2 - 0.3 in.
•
The rear brake pedal equal to about 25 - 30 mm/1- 1.2 in. of the full stroke of the pedal is required
•
for the carburetors - carburetor throttle cables synchronized
With the control levers (handles) fully depressed:
•
for the clutch — complete disengagement of the engine from the transmission; noiseless shifting
of gears means correct adjustment of the clutch cable.
•
for the carburetors — lift of throttles to maximum and equal height
CONTROL CABLE MAINTENANCE
The daily preventative maintenance involves checking the functioning, condition and fastening of
the tie rods, cables and braking action. Refer to the Service Coupons for lubrication schedule.
As per the service coupons;
•
check the condition of the brakes
•
clean the brake shoes and the active surface of the brake drums
•
lubricate the hinge pins and the cams of the brake linings, the joints, the linkage of the rear and
sidecar wheel brakes, the lever axle, the parking brake, the throttle control twist grip, the lever
pins and ends of cables used in the clutch, the front brake control, the control cables used in
the clutch, the front brake and the throttles.
Содержание Gear Up 2003
