GW-ETH-01
Factory setup
This initial setup can be restored whenever (in both GW and BL modes). This can be useful if it is not possible to establish
communication due to wrong configuration.
•
NBNS na
me
„iqrf“
•
Get IP address from DHCP server automatically
on
•
IP address
192.168.0.254
•
Subnet mask
255.255.255.0
•
Gateway
192.168.0.1
•
Primary DNS server:
192.168.0.1
•
Secondary DNS server
0.0.0.0
•
Authorization when enter the internal www page
•
username
„iqrf“
•
password
„iqrf“
•
DDNS
off
•
Getting date and time from the time server
on
•
Time server
europe.pool.ntp.org
•
Summer / winter time distinguishing
on
•
Time zone
(GMT+01:00) Prague
•
Type of communication with the TR module
Whole Packet
•
GW port for the application protocol
55300
•
Host port for the application protocol
55000
Firmware upgrade
The bootloader is a part of the GW software allowing to upload new firmware versions (delivered by the GW manufacturer)
to the GW by the user. The GW-ETH-01 Tool is a PC software intended for it. The BL mode can be also entered manually
(see
Control pushbuttons
). GW remains in the BL mode for 20 s. If no upgrade is started in this period the GW mode will be
reestablished. After upgrading the GW mode will be entered automatically. If the communication fails during the upgrade
the device is reset and stays in the BL mode. The GW uses the same network setup like in the GW mode (stored in
EEPROM) which is important for keeping the communication in case of remote upgrade. No setup changes are allowed in
the BL mode. In need, factory values can be setup manually (see
Factory setup
).
MAC address of given device is included in the BL. Thus, the device has the same MAC address after the upgrade.
Connection to internal www pages in local network
Internal web interface is intended for configuration and monitoring of the GW state. Changes should be done by the skilled
person only. Possible problems in wrong setup can be solved by restoring the factory values.
The GW must be switched
on and connected to local
LAN network. The following
text assumes the factory
setup. Enter „https://iqrf“ or
„ https://
<ip_address>“
respectively. The page
depicted below will appear.
Click the Enter button and
enter login data (login
name as well as the
password are „iqrf“).
Working with the pages are
intuitive, the state of the
device can be monitored
and all its parameters can
be setup there.
GW-ETH Tool
The GW-ETH Tool program is free to download from http://www.iqrf.org/downloads. The handling is intuitive, additionally
the Help is available. This tool offers the same possibilities for monitoring and configuration of the equipment like internal
www server and additionally the following functions are available:
© 2011 MICRORISC s.r.o.
www.iqrf.org
MNGWETH01_110218
Page 6
