B
Back
of Display
Security
Bracket (Right)
Tension Knob
Security Bracket
(Right)
Top of
Display
CC
BB
Bracket
Spacer
Note: For demonstration purposes, the wall
has been omitted from the above images.
Note: For demonstration purposes, the wall
has been omitted from the above images.
D-2
Back Plate
Padlock
Shackle
5mm (3/16”)
diameter
or less
With the Brackets attached
to the display, lift the
display and hook the
brackets onto the Wall
Plate as shown.
D-1
Lock in the desired tilt
angle by tightening the
tension knob. Like a
ratchet, the tension
knob can be pulled out
and away from the
bracket and turned
independently to
reposition the
knob (see below).
For added security, it is suggested that the left and right Security
Brackets be inserted. Additionally, a padlock can be used
through each Security Bracket and the Wall Plate to securely
prevent the display from being removed from the Wall Plate,
depending on your installation needs (padlocks not included).
Note: This procedure will
require two persons.
NOTE: When attaching the mounting
screws to the display, make sure
the direction of the brackets is right
and ensure that both brackets are
vertically aligned.
Recessed Mounting Holes: If the
mounting holes are recessed into
the back of the display, use the
supplied spacers to pack the
recessed hole. If the mounting
screw is M4, M5, or M6, use the
12.7 x 6 x 12.7mm spacers. If the
mounting screw is M8, use the
19 x 8 x 19.4 spacers. Ensure
that the brackets are securely fixed
to the display.
Mounting the Display Brackets
C
Attaching the Display to the Wall Plate
D
Q-Lock Locking Tilt and Security
Mounting
Screw
Mounting
Screw
Mounting Screw
Multi Washer
Multi
Washer
Multi
Washer
Recessed Hole
M6 & M8
Screw Hole
M4 & M5
Screw Hole
LOOSEN
TIGHTEN
Padlock
Holes
