Component Checklist
Bits Bag
IQLT1 37”- 64” UNIVERSAL TILT WALL MOUNT
Important Notes
TOOLS REQUIRED
• Power Drill
• 6mm or 10mm Drill Bit
• Phillips Head Screwdriver
• 13mm (1/2”) Socket Wrench
or Shifter
• The Universal Tilt Wall Mount supports LCD and plasma flat panel displays from 37” to 64” and
supports a maximum load of 200 lbs (91 kg). The adjustable tilt allows a -5° to +15° viewing angle.
• This product is compatible with VESA mounting centres from 500mm to 816mm wide.
• Please do not begin installation until you have thoroughly read and understood these instructions.
The manufacturer does not accept responsibility for incorrect installation.
Mounting Screws
M8x16mm / M8x45mm (x4 each)
M6x16mm / M6x45mm (x4 each)
M5x16mm / M5x45mm (x4 each)
M4x16mm / M4x45mm (x4 each)
Cross Recess Screws
Installation Instructions
1-Left Monitor Bracket (CC)
1-Right Security Bracket
1-Left Security Bracket
1-Right Monitor Bracket (BB)
Flange Screw (x4)
Washer (x4)
Masonary Wall
Plug (x4)
Multi-Washer (x4)
19 x 8 x 19.4
Spacer (x4)
12.7 x 6 x 12.7
Spacer (x4)
Timber Stud Wall
Mounting the Wall Plate
Masonry Wall
Wall Plate
OR
Masonry
Wall Plug
10mm (3/8”) Hole
6mm (1/4”) Hole
Wall Plate
Flange Screw
Flange Screw
Washer
Wall Plate
Washer
It is recommended when mounting directly into masonary wall,
that the mounting holes are positioned as far apart as possible,
and ensure not to drill directly into mortar.
TIP: Use the bubble level to ensure the wall plate is horizontal.
TIP: Use the bubble level to ensure the wall plate is horizontal.
Use a stud finder to precisely locate the timber stud and ensure
that the mounting holes are located in the centre of the stud.
It is recommended that the mounting holes are positioned as
far apart as possible.
Note: Ensure the Wall Plate is mounted
with the folded tabs pointing upwards.
Note: Ensure the Wall Plate is mounted
with the folded tabs pointing upwards.
