SECTION ONE
GENERAL INFORMATION
Unit is for indoor or outdoor use. Unit must be mounted as a fixed luminaire, and is not suitable
for portable use.
PARTS INCLUDED
- Low Energy Bulkhead
- Instruction manual. Please keep safe for future reference.
- Accessory Pack including screws and wall plugs
- 28W PL-Q 4pin GR10q low energy lamp.
TOOLS & PARTS NEEDED
- 3 flexible core cable (1.0mm² or 1.5mm²)
- Electric/hand-held drill & bits
- Terminal or Electricians screwdriver
- Wire cutters
Do not attempt to install during wet weather, if you are suffering from nausea or dizzy spells or on
medication with similar side effects.
SECTION TWO
INSTALLATION
*** IMPORTANT ***
Switch off the electricity at the fuse box by removing the relevant fuse or switching off
the circuit breaker before proceeding with the installation.
After choosing a suitable location install the unit as follows:
The unit is suitable for connection to a 240 V ac 50Hz electricity supply. It is suggested that
3-core round flexible cable of 1mm² or 1.5mm² gauge is used. An internal switch should be
installed to switch the power to the unit ON & OFF. This allows the unit to be easily switched off
when not required or for maintenance purposes.
It is recommended that the circuit is protected by a 5A max fuse or circuit breaker.
It is recommended that this product is connected to fixed wiring only.
Using a large flat blade screwdriver or coin, carfully insert the edge into the aperture at the top
and bottom of the unit, see diagram A, and carefully twist. The front cover will detatch from the
base. Store the front cover in a safe place whilst continuing with the installation
Position the unit in the desired position based on the location of the incoming power cable.
Using the unit as a template, mark the position of the mounting holes. See diagram B.
Note the "UP" ident on the inside of the wall plate.(Diagram B).
Choose 2 mounting holes, Drill the holes, insert the wall plugs into the holes.
PIERCE AND PASS THE CABLE THROUGH THE GROMMET BEFORE SECURING THE UNIT
TO THE WALL.It is recommended that the grommet is pierced with a screwdriver to ensure a
better seal.
Fix the unit to the wall
