3.
Operating of Casters (Optional) –
To lock casters
– Pull caster hand lever in up-
right position, perform this function for each caster. This will ensure unit will remain
stationary while in use or being stored.
To unlock casters
- push caster hand lever in downward position. Each caster must
be unlocked in order to relocate the unit.
Removing casters
– First, lock all casters. Lift unit with forklift (please refer to
Item 4) to an adequate height. Provide support beneath the caster and remove re-
taining pin in from shaft. Slide each caster out of it’s shaft. Place each retaining pin
around the corresponding wheel stow and slide each caster into the wheel stow
housing.
Installing casters
– Unit must be secured to a forklift (please refer to Item 4). Re-
move each caster and retaining pin from the wheel stow housing; slide each caster
into it’s shaft and secure with a retaining pin. Lock each caster prior to lowering unit
from forklift, to ensure that unit will remain stationary on surface.
4.
Prepare for Transport–
Moving and lifting unit by forklift- Verify that the unit is
not plugged into power source, main door and dust bucket must be secure and cast-
ers locked. Align forklift with fork tubes on the base of the unit, precede forward
until fork is securely inserted in tubes. Lift unit to an adequate height in order to
remove casters. Unit can now moved to the desired location. If unit is being trans-
ported, tie down unit securely to a fixed position.
5.
Power On–
The on/off switch is located on the side panel of the unit. If the unit
does not power on, or shuts down after prolonged use in high temperature environ-
ments, the thermal overload protection circuit
may have become activated. If so, please wait
10 minutes before powering on again.
6.
Shaking Operation-
This unit is equipped
with a shaking mechanism to clear the filter
element of dust for optimum suction. Before
and during use, (30-60 min. as needed) peri-
odically power off the unit, the manual shaking
handle should be moved vigorously up and
down ten times, power on unit.
OPERATING INSTRUCTIONS
6
