IQ Power Tools X-STAND Скачать руководство пользователя страница 3

Страница: 3 / 5

X-STAND

Operator’s Manual

iQ Power Tools

888-274-7744

www.iqpowertools.com

INSTALLING THE X-STAND (optional accessory)

With the saw resting on the wheels and back feet.

Hold the X-Stand as shown. Connect hooks on

X-Stand (A) over upper crossbar of saw tube frame.

Put slight pressure on transport handle (A) while

pushing X-Stand down (B) until lower cross bar of saw

tube frame engages with X-Stand lock pin.

Lower the transport handle by pulling transport

handle lock pin (A) then pushing down on transport

handle (B).

With X-Stand attached lifting the machine to its

upright operating position. As shown below, with left

foot placed near cutting head (A) with left hand lift

on cutting head handle while guiding upward rotation

with right hand on transport handle (C).

Note:

Before

lifting allow approximately 6ft. / 2m to lift and rotate

the machine to its upright operating position.

WARNING!

WARNING! BE SURE TO LOCK

THE ROLLING TABLE BEFORE

TRANSPORT TO AVOID EQUIPMENT DAMAGE OR

PERSONAL INJURY.

Содержание X-STAND

Страница 1: ...X STAND Operator s Manual To be used with the iQTS244 ...

Страница 4: ...ng the optional X Stand With your right hand on transport handle C and left hand on cutting head handle B rotate the machine back Note Before lowering allow approximately 4 ft 1 5 m to behind the machine to rotate the machine down to the floor Guide machine back to rest softly on the floor 1 2 X STAND C B ...

Страница 5: ...d from machine Machine can now be tipped forward onto the wheels for easy transport Raise the transport handle by pulling transport handle lock pin A then pulling up on transport handle B With slight pressure against transport handle A with tip of left foot pushed down on X Stand lock pin knob B then pull up with right hand C 3 4 5 6 X STAND A B A B C B CLOSE UP B A ...