5
REMOTE CONTROL
When using the remote control aim it directly to the unit’s receiver module:
-
By pressing A, C buttons the unit will make two ‘Tick’ sounds
- By pressing B
, D buttons the unit will make one ‘Tick’ sound
TIPS:
The remote control is based on infra-red light waves being emitted. Therefore please
ensure the head of the remote control is not blocked in any way, as this will prevent
the unit from receiving the infra-red signal from the controller.
Low voltage batteries installed in the remote controller will shorten the distance the
remote control can be used.
During long periods of time when the remote control is not being used, please
remove the batteries to avoid any damage to the circuitry.
Manual
Recording
(A)
Enable
Motion
Detection
(C)
Disable
Motion
Detection
(D)
Stop
Recording
(B)
Please Note: The sounds confirming the unit has received instructions
from the remote control can be switched on/off by the user. Please see
the section ‘Configuration’ for further detail (page 8).
