10
4
Choose temperature
thermostat with 2 adjustable temperatures can be installed.
The choice of temperature via the switch buttons can then be replaced by the input
of T1/T2
- T2 = Highest adjustable temperature (Main wash)
- T1 = Lowest adjustable temperature (Pre-wash)
Press the start button (6). When the machine is started, the red control lamp on
the fascia panel (A) will light up.
Start the machine
Orange pilot lights
When the middle orange pilot light (B) lights up, the liquid bleach may be added
manually (Compartment D).
When the bottom orange pilot light (C) lights up, the linen softener is automatcally
added or the starch pay be added manually (compartment D)
When the red pilot light on the fascia panel turns off, the wash cycle has come
to an end and you can open the door.
End of the cycle
Button 6: START.
Press this button and release immediately to start a program.
Button 7: STARCH.
To starch at the end of a wash cycle proceed as follows:
- In case you dont want to starch some of the linen, remove these first.
- Dissolve the starch in some water.
- Press button 7.
- Press button 6 and release it.
- Add the dissolved starch (in compartment D) when water flows into the
soap dispenser.
- Program sequence: Water inlet - Starch:2' - Drain:30" - Spin:130 - Tum-
ble:30".
- After ending the starch program, press out button 7.
Button 8: HIGH WATER LEVEL (reduced wash action)
If you want to wash in a certain program with high water level and reduced wash
action, press button 8. After ending the program, press out button 8.
Button 9: NO SPIN
If you want to run a program without spinning, press the button 9 before
you press the start button. After ending that program press out this button
9. You can also choose 8 & 9 at the same time to wash with reduced wash
action, high water level and without spinning.
Button 10: RAPID ADVANCE.
With this button you can at any time skip a part or the rest of the program.
Remarks
Function buttons (6-10)
p
p
p
p
p
