Page 12
Electric connection
The connection needs to be made in the wiring box at the back. Remove the
coverplate (G) in order to reach the connection clamps.
The connection cable needs to be brought in through the swivel (H) on the
side of
the wiring box.
It is necessary to
ground
the dryer for your personal safety and to ensure a good
operation.
115 and 208-240 V - 1 ph
The mains wires
(Ll)
and
(L2)
should be connected to the 2 left clamps and the
yellow/green grounding wire (PE)
should be connected to the grounding clamp.
208-240 and 480 V - 3 ph
The
3 mains wires (L1), (L2) and (L3)
should be connected to the 3 left clamps and
the
yellow/green grounding wire (PE)
should be connected to the grounding
clamp.
380-415V - 3 ph
The
3 mains wires (L1), (L2) and (L3)
should be connected to the 3 left clamps,
the
blue neutral (N)
should be connected to the right clamp and the
yellow/green
grounding wire (PE)
should be connected to the grounding clamp.
G
H
Dryers must be electrically grounded
by a separate #14 or larger green wire from the
grounding
terminal
within the Service Connection Box, to a cold water pipe. In all cases, the grounding method must
comply with
local electrical code requirements
; or in the absence of local codes, with the
National
Electrical Code, ANSI/NFPA No. 70 or the Canadian Electrical Code, CA C22.1.
See wiring diagram furnished with dryer.
Do not change wiring without consulting the factory, as you
may void the factory warranty.
DO NOT CONNECT THE DRYER TO ANY VOLTAGE OR
CURRENT OTHER THAN THAT SPECIFIED ON THE DRYER RATING PLATE.
(Wiring diagram
is located on rear wall of dryer.)
All panels must be in position before operation of dryer.
115 and 208-240 V - 1 ph
208-240 and 480 V - 3 ph
380-415V - 3 ph
N
L3
L2
L1
«Attention. Lors des opérations d’entretien
des commandes, ètiqueter tous les fils avant
de les dèconnecter. Toute erreur de câblage
peut être une source de danger et de panne»
