Better Packages
Section 1
Unpacking and Setup
6
Procedure:
1. Remove a guide from its current position by grasping the guide, lifting it up and pulling the bottom of it
to the rear of the unit.
See Figure 2.
2. Reinsert each guide pressing it first into the front slot and then into the bottom slot.
See Figure 3.
FIGURE 3
• Set the space between the guides to just larger than the width of the tape.
• Use the guides to center the tape as much as possible by inserting each guide into a slot the same
distance from the outside edge of the panel. For example, if you set the bottom part of the guide in the
second slot from the outside edge of the panel, set the front part of the guide also into the second slot from
the outside edge.
LOADING THE TAPE
1. Cut the end of the tape so that it has a clean, square end to feed under the
drive wheel.
2. Load the tape roll into the basket so that:
• The adhesive side is down.
• The roll is upright between the roll guides.
See Figure 4.
• The end of the tape goes over the:
- Top of the tape roll from back to front.
- Lift Roller then rubber Roller
• The end of the tape is fed under the top tape plate and drive wheel; and is
butted against the shear blade.
3. Close the top cover.
Feed the tape:
• Adhesive side down
• Around the lift roller
• Over the black roller
• Under the upper tape plate
• Under the guide bar
• Up against the shear blade
FIGURE 2 - Removing the Guides from the Slots
Insert all four tabs the same number of
slots from the outside edge.
ROLL GUIDES
Lift Roller
Black Roller
Upper Tape Plate
Shear
Blade
FIGURE 4 - Loading the Tape Roll
