CM-IW2000 V2 Instruction Manual
4
5.
Prior to placing the mounting frame into the wall, pull a sufficient
length of the wire through the wire opening in the side of the
mounting frame, as shown in figure 4.
Note: Tie a knot in the wire to allow the wire to catch on the
mounting frame to avoid falling into the wall cavity.
6.
Insert the Control Mount mounting frame into the opening in
the wall.
7. Hand-tighten the four Roto-Lock screws on the Control Mount’s
mounting frame as shown in Figure 5. The Roto-Lock clamps
will automatically rotate into position behind the wall and begin
clamping the mount.
• When you notice resistance on the four screws, the Control
Mount has been clamped successfully.
IMPorTANT: NEVEr over-tighten the roto-Lock screws.
8. Mount iPad to the bezel by placing iPad into nesting area on
rear of bezel and attach metal retainer with ten (10) machine
screws and washers as shown in figure 6 with the #1 Phillips
screwdriver.
Figure 4: Mounting Frame
Figure 5: Roto-Lock Screw Locations
Figure 6: Mounting iPad to bezel
Note: Please use the provided fit kit for iPad
(4th generation), (3rd generation) and iPad 2.
