_____________________________________________________________________________________________________________
7
CONC_TR_017, 22/10/2019, Version 01
3.
Safety recommendations
3.1.
DANGER
For equipment permanently connected to the mains, a readily accessible disconnect device must
be incorporated into the installation. For equipment connected via a mains socket, the socket must
be installed near to the equipment and easily accessible.
SELV (separated extra-low voltage) information: all of the equipment's circuits are SELV, apart from
the 115/230VAC mains power supply circuit. The SELV circuits must be connected to external
equipment with interfaces which are supplied by circuits of the same type (compliant with SELV
circuit requirements).
N.B. some parts of the device may have hot surfaces.
Some printed circuit boards have lithium batteries installed. Ensure that these batteries are
replaced with a model approved by the PCB manufacturer and pay particular attention to the + and
- polarity. There is a risk of explosion if the battery is not replaced correctly.
If the product contains a lithium metal battery, it contains less than 1g of lithium. IATA regulations
relating to air transport must be observed in addition to laws in the shipping and destination
countries.
The 115/230VAC mains power supply cable must be connected to an earthed socket.
The installation and use of this equipment must comply with applicable standards. The device must
be connected to a standard-compliant electrical installation.
3.2.
CAUTION
This device must be set up by competent personnel with the relevant training and qualifications.
Any dismantling or modification of the device will result in the immediate loss of warranty and will
void IPO Technologie's liability for any consequences of any type.
Switch off the device before disconnecting any cables.
Ensure that you have discharged any static electricity from yourself before handling the device.
The device contains components which are sensitive to electrostatic shock.
