www.ipnxnigeria.net
ip
NX
Step 1
Power off your network devices, including your modem and PC then connect the RJ-11 phone cable to the ATA's
Phone 1 port (and port 2 if you have 2 lines). Connect the other end to your analogue telephone(s).
Step 2
Connect one end of an Ethernet network cable (included) to the Ethernet port of the ATA. Connect the other end to
the Ethernet port of your PC.
Step 3
Connect one end of a different Ethernet network cable to the Internet port of the ATA. Connect the other end to
your cable/DSL modem then power on the broadband modem.
Step 4
Connect the included power adapter to the ATA’s power port, and then plug the power adapter into an electrical
outlet. The power LED on the front panel will light up as soon as the ATA powers on. Afterwards, power on your PC.
Step 5
Launch the web browser on the PC and type
http://192.168.0.1/admin/resync?http://cfg.ipnxtelecoms.com:80/spa/00012345ABCD.xml
on the address bar.
Replace the 00012345ABCD with the actual MAC Address found underneath the ATA. The ATA will reboot in about
20-30 seconds. Pick the phone handset and listen for a dial tone. Dial 129 and listen for the voice prompt which will
read out your number (save where necessary).
At this point you should be able to make calls. Please ensure you have credited your line before making outbound
(i.e. off-net) calls. For your account balance dial 123.
For further assistance with the ATA setup, contact us via:
,
www.ipnxnigeria.net
or +234 (1)
628 1111
